Skip to content
Ai Builders Electric
Discuss your projectContact

Electrical services / Greater Los Angeles

Three-Phase Power, 208V and 480V Service

Confirm the building supply before ordering the machine. Voltage, phase and equipment requirements determine whether the existing distribution can serve it and what changes may be needed.

Discuss your project
Real company project photography. Explore the project library

The configurations you will actually meet

Common arrangements include single-phase 120/240V, three-phase 120/208V and three-phase 277/480V, but the actual supply must be verified. Older installations can use other configurations. Compare the equipment’s voltage, phase and connection requirements with the building information before ordering; names, plug shapes and enclosure appearance are not enough.

Match equipment to the building supply

The expensive version of this is a machine arriving on site that the building cannot run. A piece of equipment specified for 480V three-phase does not work on 208V by being wired differently, and a transformer or a different model is then an unplanned cost against a schedule that has already started. We check the nameplate requirements against the actual service before anything is ordered where we are asked early enough, and where we are not, we tell you straight away what the options are: a step-up or step-down transformer, a service change, or a different machine. Rooftop units, compressors, lifts, kitchen equipment and machine tools are where this comes up most.

Conversions, distribution and capacity

Changing a building from single-phase to three-phase supply requires review of utility availability and the proposed equipment. A transformer changes voltage; it does not by itself create three-phase power from a single-phase source. Other equipment-specific arrangements may be considered where suitable. We review the service, distribution, protection and connection requirements before identifying the electrical scope.

Common questions

Can I run 480V equipment on a 208V service?

Not directly. It needs a step-up transformer, a service change, or different equipment. Which of those makes sense depends on the load, how much else you are running and what the utility can supply. We will price the realistic options rather than assume the largest one — but check before you order, because afterwards your choices narrow.

What is the high leg on a 240V delta service?

On a 240V delta with a center-tapped transformer, one phase sits around 208V to neutral rather than 120V. Connecting a 120V load to it damages equipment. It is marked orange by convention, but in old installations conventions were not always followed, which is why we verify rather than trust the color.

Can you get three-phase into a building that does not have it?

Possibly, after utility availability and equipment requirements are checked. Where a utility supply change is not available or practical, a suitably designed equipment-specific solution may be considered. A transformer alone does not convert single-phase supply to three-phase. Confirm the supported arrangement before purchasing equipment.

Technical planning notes & references

BEFORE WE QUOTE THE WORK

Confirm voltage and phase before ordering equipment

Use manufacturer requirements

208-volt and 480-volt systems are not interchangeable. A plug or enclosure does not establish supply requirements. Voltage, phase, load, starting characteristics and connection instructions guide the design. A transformer or utility change may be part of the solution.

Review the distribution path

Capacity, protection, disconnects, grounding, equipment ratings and routes all need assessment. Establish utility availability before promising a supply. Coordinate shutdowns and commissioning with the equipment supplier and property team.

Official reference: Schneider Electric: single-phase supply and three-phase transformers

What are you looking for?

Call the teamDiscuss your project